LP-103 Laser Standard by AdirPro
AdirPro’s LP103 Cross Line Laser is a self leveling horizontal and vertical alignment tool with an accuracy of within 3°. The two, independent line beams are generated from a 10mw 635nm laser diode. The beams generated have±3mm accuracy at up to 3m. Design Small, and compact, this cross line laser is easy to handle. Weighing just 10 oz, this unit can fit in the palm of your hand. It’s easy to transport and has a minimal storage footprint. The LP103 has a user friendly operation. The laser is operated with just one button (in addition to the power button) to switch between the 4 operation modes. The heavy duty plastic is trimmed with a thick rubber casing to protect the model against standard bumps that occur during transportation and on a jobsite. Leveling The unit uses a magnetic damping compensator to provide a quick leveling. Once the unit levels itself the highly visible horizontal and vertical beams stabilize allowing you to use it for alignment almost immediately. So long as the laser beam is a constant line you know that the laser is leveled. The unit will indicate that it is out of self-leveling range by changing the laser beam from being a constant line to a blinking one. Additionally, there is a built-in locking system to ensure that the compensator does not shift during transportation due to vibrations. Mounting Options The threading of the LP103 Cross Line Laser nut is ¼”. It comes with a coordinating standard L-shaped mounting bracket. The laser can be mounted directly to the bracket (once it’s secured to the wall) or onto a tripod that has a ¼” threading (or if you have a 5/8” to ¼” male adapter). As an extra bonus, there is a ¼” adapter included so that you can secure the bracket to a tripod and the unit to the bracket. Accessories The LP103’s standard outfit includes laser, wall mount, securing adapter, soft, red target, and a soft carrying case. Your first set of 3 AA batteries is included as well. This product is warranted to the original purchaser, only, and is not transferable. If there is failure of product due to defects in material and workmanship, upon proof of purchase, AdirCorp®/AdirPro®/AdirMed® will repair or replace the product at our own discretion, without charge. Warranty is void if product is subject to misuse, abuse, alteration, improper assembly, accident, if used for other than designated purpose, or if maximum load capacities are exceeded. This warranty does not cover chipping, flaking, scratches, rust, dents, or other damages to the finish or surface of the product. Responsibility of AdirCorp®/AdirPro®/AdirMed® is limited to repair or replacement of product at our discretion. AdirCorp®/AdirPro®/AdirMed® is not responsible for consequential, incidental, or other damages resulting from product failure. (THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU.) THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE. In case of product failure, (damaged or defective material), contact AdirCorp®/AdirPro®/AdirMed®, at firstname.lastname@example.org, 27 Selvage Street, Irvington, NJ 07111 or 845-738-1467.